Planet SGS-6341-24T4X - Page 537

34-176
command disables this function.
Parameter:
<access-list-number |access-list-name> is the access-list or name to be applied.
<number> is the additional offset value, ranging between 0-16;
<ifname> is the name of specific interface.
Default:
The default offset value is the metric value of the interface defined by the system.
Command Mode:
Router mode
Example:
Switch#config terminal
Switch(config)#router ipv6 rip
Switch(config-router)#offset-list 1 in 5 Vlan1
Related Command:
access-list
34.14 passive-interface
Command:
passive-interface<ifname>|vlan <vlan-id>
no passive-interface<ifname>|vlan <vlan-id>
Function:
Set the RIPng layers 3 switches to block RIPng broadcast on the specified interfaces, and only send
the RIPng data packet to the layer 3 switch which is configured with neighbor.
Parameter:
<ifname> is the specific interface name.
Default:
Not configured
Command Mode:
Router mode
Example:
Switch#config terminal
Switch(config)#router ipv6 rip
Switch(config-router)#passive-interface Vlan1
Related Command:
show ipv6 rip