Planet SGS-6341-24T4X - Page 812

44-88
44.8.5 ip multicast destination-control access-group
(vmac)
Command:
ip multicast destination-control <1-4094> <macaddr >access-group <6000-7999>
no ip multicast destination-control <1-4094> <macaddr >access-group <6000-7999>
Function:
Configure multicast destination-control access-list used on specified vlan-mac, the “no ip multicast
destination-control <1-4094> <macaddr >access-group <6000-7999>”command deletes this
configuration.
Parameter:
<1-4094>: VLAN-ID;
<macaddr>: Transmitting source MAC address of IGMP-REPORT, the format is “xx-xx-xx-xx-xx-xx”;
<6000-7999>: Destination-control access-list number.
Command Mode:
Global Mode
Usage Guide:
The command is only working under global multicast destination-control enabled, after configuring
the command, if IGMP-SPOOPING is enabled, for adding the members to multicast group. If
configuring multicast destination-control to source MAC address of transmitted igmp-report, and
match configured access-list, such as matching: permit, the interface can be added, otherwise do
not be added.
Example:
Switch(config)#ip multicast destination-control 1 00-01-03-05-07-09 access-group 6000
44.8.6 ip multicast policy
Command:
ip multicast policy <IPADDRESS/M> <IPADDRESS/M> cos <priority>
no ip multicast policy <IPADDRESS/M> <IPADDRESS/M> cos
Function:
Configure multicast policy, the “no ip multicast policy <IPADDRESS/M> <IPADDRESS/M> cos”
command deletes it.
Parameter:
<IPADDRESS/M>: are multicast source address, mask length, destination address, and mask
length separately.