Planet SGS-6341-24T4X - Page 859

45-5
Switch (config)#ipv6 pim multicast-routing
Switch (config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 pim dense-mode
45.2.6 ipv6 pim dr-priority
Command:
ipv6 pim dr-priority <priority>
no ipv6 pim dr-priority
Function:
Configure, cancel and change priority value of interface DR. The same net segment border nodes
vote specified router DR in this net segment through hello messages, the “no ipv6 pim dr-priority”
restores default value.
Parameter:
< priority> priority, value range from 0 to 4294967294
Default:
1
Command Mode:
Interface Configuration Mode
Usage Guide:
Value range is from 0 to 4294967294, the bigger value, the more priority. The command can
configure on IPv6 tunnel interface, but it is successful configuration to only configure tunnel
carefully.
Example:
Switch (config)# interface vlan 1
Switch(Config-if-Vlan1)ipv6 pim dr-priority 100
45.2.7 ipv6 pim exclude-genid
Command:
ipv6 pim exclude-genid
no ipv6 pim exclude-genid
Function:
The command make Hello message transmitted by PIM-SM exclude Genid option, the “no ipv6
pim exclude-genid” restores default value.
Default: