7-12 Phaser 6300/6350/6360 Color Laser Printer Service Manual
Cleaning and Maintenance
26. Re-install the Developer Frame Assembly, the HVPS, and Door C.
Note
Match the colors of the 4 toner nozzles to the correct positions on the
Developer Frame Assembly before attaching them.
Before reinserting the pins for Door C, verify that the shoulders on the
end of each pin faces out and the bosses on the Developer Frame
Assembly guides are set in the notches provided in Door C.
27. Remove 4 screws (self-tapping, plastic 10 mm) that secure the
Registration Roller.
o
e
Observe the wire routing between the Registration Roller and Engine
Control Board. Route the wires in the same manner upon re-installation.
28. Disconnect the two connectors connected to Registration Chute.
29. Move the Registration Roller Assembly to the left and lift it up to remove.
Note
Be sure to re-install the wiring harness and connectors between the
Registration Roller and Engine Control Board as noted in Step 26.
Failure to correctly route the wiring can interfere with the Imaging
Unit.
Insert the Registration Clutch into the opening first. Lower the
opposite end as the Registration and Turn clutches engage the gears.
30. Install the replacement Registration Roller Assembly.
s6360-159
To Next Page
Loading...
