Programming
2777
SCPI.TRIGger.SEQuence.SINGle
Object type
Method (Write-only)
Syntax
SCPI.TRIGger.SEQuence.SINGle
Description
This command generates a trigger immediately and executes a
measurement, regardless of the setting of the trigger mode.
This command is different from SCPI.TRIGger.SEQuence.IMMediate as the
execution of the object finishes when the measurement (all of the sweep)
initiated with this object is complete. In other words, you can wait for the
end of the measurement using the SCPI.IEEE4882.OPC object.
If you execute this object when the trigger system is not in the trigger wait
state (trigger event detection state), an error occurs when executed and
the object is ignored.
For details about the trigger system, see Trigger System.
Examples
Dim Dmy As Long
SCPI.TRIGger.SEQuence.SOURce = "bus"
SCPI.INITiate(1).CONTinuous = True
SCPI.TRIGger.SEQuence.SINGle
Dmy = SCPI.IEEE4882.OPC
Related objects
SCPI.TRIGger.SEQuence.IMMediate
SCPI.IEEE4882.OPC
Equivalent key
No equivalent key is available on the front panel.
Equivalent SCPI command
Syntax
:TRIGger[:SEQuence]:SINGle
Example of use
10 OUTPUT 717;":TRIG:SING"
20 OUTPUT 717;"*OPC?"
30 ENTER 717;A
To Next Page
