Controlling Multiport Test Set
2907
E5091A Front Panel
Operational Procedure
1. Press System Key, then click Multiport Test Set Setup > Test Set 1 or
Test Set 2.
2. Press Channel Next (or Channel Prev) to activate the channel for
which you want to set the control line.
3. Click Control Lines for E5091A or Control Line A/B/C/D for E5092A to
display the settings menu for the DUT control line.
4. Use the corresponding softkey to set the control line of the multiport
test set.
Softkey Function
Line 1 to Line 8 Set High/Low of each line of the
control line.
DC source (only for
E5092A)
Set DC source voltage.
5. Execute Step 3 through Step 4 for all channels that you want to
sweep.
To Next Page
Loading...
