E5071C
360
displayed are 1-2-3, 1-2-4, 1-3-4, and 2-3-4. If you want to save the
data of the channel for which port 1, port 2, and port 4 are
measured, press 1-2-4.
7. SaveAs dialog box opens. For its operations, use an external
keyboard and mouse.
8. Specify the folder to which the file should be saved, enter a file
name, and then press Save to save the file.
9. When saving data in a sweep process, the data during sweep is
saved into a Touchstone file. That is, the previous sweep data is
saved as data that has not been swept; or, if sweep was not
performed previously, zero data might be saved. Therefore, you
should set the active channel to the HOLD state when saving
data into a Touchstone file.
To Next Page
Loading...
Need help?
General
