Agilent Technologies E5071C User Manual

E5071C
762
allowed IEEE488.2).
H
No. Message Description
-114
Header suffix
out of range
The unit of the header is outside the range.
The header is invalid in the unit for numeric
parameters following a SCPI command.
I
No. Message Description
-224
Illegal
parameter
value
The parameter value is not suitable. This
error occurs when the CALC:PAR:DEF
command is used to specify an S-parameter
that does not exist in the model (S44 in the
case of a 2-port model), for example.
-282
Illegal
program
name
This error occurs when a nonexistent VBA
program name is specified by the
PROG:SEL:NAME command.
-213 Init ignored
Because another measurement is in
progress, the request for initiating a
measurement ("INIT" command) is ignored.
35
Insufficient
ECal module
memory
This error occurs when the embedded
memory is insufficient to save the user
property in ECal module during the user
definition ECal processing.
-161
Invalid block
data
Block data has been expected, but the block
data that appears is invalid for some reason
(see 7.7.6.2, IEEE488.2). The END message
is received before the length of block data
has been filled, for example.
28
Invalid
calibration
method
This error occurs when the type of
calibration is not specified or not correct
when partial overwrite is executed with the
GPIB command. This error does not occur
for operation with front keys.
-101
Invalid
character
An invalid character exists in the program
message character string.

Agilent Technologies E5071C Specifications

General

Brand	Agilent Technologies
Model	E5071C
Category	Measuring Instruments
Language	English