E5071C
772
avoid duplication of ports. This error is
not generated by front key operations.
51
Specified trace
dose not exist
This error occurs when CALC:PAR:SEL
command is executed to activate more
traces than specified by
CALC:PAR:COUN command. This error
is not generated by front key
operations.
26
Standard not
selected
This error occurs when you execute
the measurement under the condition
that the standard is not selected for
the subclass (the standard number is
set to 0).
-150 String data error
When a character-string-data element
is put to syntactic analysis, an error
not corresponding to one of Error
Numbers -151 through -159 occurs.
-158
String data not
allowed
A character-string-data element has
been received at a position where this
instrument does not accept one.
-138
Suffix not
allowed
A suffix is attached to a numeric value
element to which a suffix is not
allowed to be attached.
-134 Suffix too long The unit is too long.
The unit is expressed in 12 or more
characters (see 7.7.3.4, IEEE488.2).
55
Sweep mode
changed to
stepped sweep.
You cannot change the sweep mode to
the swept mode. This error occurs
when you change the sweep mode to
the swept mode/high speed swept
mode under the conditions where the
sweep type is set to power sweep,
power slope function is enabled (ON,
correction coefficient is other than
zero), power calibration is ON,
frequency offset is enabled, spurious
avoidance of frequency offset is
enabled, or external signal source
To Next Page
Loading...
Need help?
General
