Agilent Technologies E5071C

E5071C
890
Firmware Revision History
• Firmware Revision History
• A.09.61
• A.09.60
• A.09.5x
• A.09.4x
• A.09.31
• A.09.30
• A.09.2x
• A.09.1x
• A.08.1x
• A.08.0x
• A.07.0x
• TDR software Revision History
• A.01.02
Other topics about Revision History
Firmware Revision History
A.09.61
• S6P/S8P are supported.
A.09.60
• Turning ON/OFF segment individually (Segment Sweep) is supported.
• Setting multiple range is allowed.
• Multiple ECal connection is added.
• Sliding load and offset load calibration is supported.
• RAW data array is readable.
• Trace data direct selection is allowed.
• Trace name assignment is allowed.
• The following commands have been added.
• SCPI.SENSe(Ch).SEGMent.LIST.CONTrol.DATA
• SCPI.SENSe(Ch).SEGMent.LIST.CONTrol.STATe