Programming
983
• For alias, use the ASCII format less than 127 digits. Alias is
upper/lower case insensitive.
• If Never show this dialog is selected in Show this dialog frame,
the dialog box does not appear even if a new device is
connected.
• Once new device is identified, the "New Hardware Search
Wizard" will start. Follow the instruction to implement the
processing.
3. Changing Alias on Setting Screen
The following are steps using the Agilent I/O Libraries Suite 14.2.
1. From the Start menu of your PC, click Programs > Agilent IO Libraries
Suite > Agilent Connection Expert to open the Config setting screen.
2. In the Config setting screen, select the alias names from USB0
onward in the Instrument I/O on this PC frame, and then use the
Change Properties from I/O Configuration on the menu bar.
Changing Alias
To Next Page
Loading...
