Programming
1001
Showing/hiding a table or echo window
You can display the following items at the bottom of the LCD screen:
• Segment sweep table
• Limit table
• Marker list table
• Echo window (a window that displays messages from a custom
program)
• Loss compensation table
• Power sensor's calibration factor table
To show or hide each of the above items, use the following command:
:DISP:TABL
You cannot have two or more of the above items displayed at a time. The
screen displays only the selected item by using the following command:
:DISP:TABL:TYPE
Showing/hiding softkey labels
You can show or hide the softkey labels placed alongside the right-hand
edge of the LCD screen. To show or hide the softkey labels, use the
following command:
:DISP:SKEY
Configuring Trace Display Settings
Selecting which traces to display
Each trace has two different representations: data and memory traces. You
can show or hide the data and memory traces independently of each other.
To show or hide the data or memory traces, use the following commands:
Type Command
Data trace
:DISP:WIND{1-36}:TRAC{1-36}:STAT
Memory trace
:DISP:WIND{1-36}:TRAC{1-36}:ANN:MARK:POS:X
To copy the data trace to the memory trace, use the following command:
:CALC{1-36}:MATH:MEM
Configuring cross-trace math operations
To Next Page
Loading...
