E5071C
1002
You can perform math operations between the data and memory traces
and have the results displayed as the data trace. To perform cross-trace
math operations, use the following command:
:CALC{1-36}:MATH:FUNC
Configuring smoothing settings
To turn on/off smoothing, use the following command:
:CALC{1-36}:SMO
The smoothing aperture is expressed as a percentage with respect to the
sweep range. To set the smoothing aperture, use the following command:
:CALC{1-36}:SMO:APER
Selecting the data format
You can select the following data formats:
Rectangular display formats
• Log magnitude format
• Phase format
• Group delay format
• Linear magnitude format
• SWR format
• Real format
• Imaginary format
• Expanded phase format
• Positive phase format
Smith chart format
Polar format
To select the measurement parameter data format, use the following
command:
:CALC{1-36}:FORM
Configuring the display scale
Depending on the measurement parameter data format, you can configure
the display scale in one of the following two ways:
Rectangular display formats:
To Next Page
