Agilent Technologies E5071C

E5071C
1016
To select a standard type, use the following command:
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30}:TYPE
Setting the Standard Name
To set the standard name, use the following command:
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30}:LAB
Setting the Standard Value
To set the standard value, use one of the following commands:
Item Command
C0
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :C0
C1
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :C1
C2
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :C2
C3
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :C3
L0
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :L0
L1
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :L1
L2
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :L2
L3
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :L3
Offset Delay
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :DEL
Offset Loss
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :LOSS
Offset Z0
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :Z0
Arbitrary Impedance
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30}: ARB
Start Frequency
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :FMIN
Stop Frequency
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30}: FMAX
Media Type
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :CHAR
Length Type
:SENS{1-160}:CORR:COLL:CKIT:STAN{1-30} :LTYP