Programming
1067
You can only turn on or off Network De-embedding for all of the ports, not
for each port individually. However, any port whose Network De-
embedding type is set to "None" behaves as if this feature were
permanently off.
Selecting a Type
To select a Network De-embedding type, use the following command:
:CALC{1-36}:FSIM:SEND:DEEM:PORT{1-4}
Specifying the File
To specify the file that defines the criteria for Network De-embedding, use
the following command:
:CALC{1-36}:FSIM:SEND:DEEM:PORT{1-4}:USER:FIL
4-Port Network Embedding/De-embedding
The 4-port Network Embedding/De-embedding feature is provided to
embed or de-embed a network (defined in a 4-port touchstone file)
between the calibration surface and the DUT.
On/Off
To turn on or off the 4-port network embedding/de-embedding feature,
use the following command:
:CALC{1-36}:FSIM:EMB:STAT
Setting Topology (connection method between analyzer and DUT)
To select a connection type, use the following command:
:CALC{1-36}:FSIM:EMB:TYPE
Connection type
To Next Page
Loading...
Need help?
General
