E5071C
1068
To assign the ports (ports a through d in Connection_type), use the
appropriate command that matches your selected connection type, as
identified in the following table:
Connection type Command
A
:CALC{1-36}:FSIM:EMB:TOP:A:PORT
B
:CALC{1-36}:FSIM:EMB:TOP:B:PORT
C
:CALC{1-36}:FSIM:EMB:TOP:C:PORT
Selecting Processing Type (embedding/de-embedding)
To select a network processing type, use the following command:
:CALC{1-36}:FSIM:EMB:NETW{1-2}:TYPE
Specifying File
To select a file that defines the criteria for network embedding/de-
embedding, use the following command:
:CALC{1-36}:FSIM:EMB:NETW{1-2}:FIL
Balance-Unbalance Conversion
The Balance-Unbalance Conversion feature converts the measurement
results obtained in an unbalanced state to the characteristics of a balanced
state. You can select mixed mode S parameter, balance and CMRR as the
measurement parameter when you turn on Balance-Unbalance Conversion.
To Next Page
Loading...
