Ducati ST3 2004 - Page 63

Caratteristiche tecniche
Technical specification
sezione / section
C 3
32
A
B
C
D
E
F
G
H
L
M
N
P
ST3 - M.Y. 2004 - edizione/edition 00ST3-
Engine torque settings
Part Thread (mm) Nm tolerance ±10% Notes
Blow-by valve M 40x1.5 40
Mesh filter blanking cap M 32x1.5 42
Coolant intake manifold M 30x1.5 30 LOCK 6
Oil temperature sensor holder ring nut M 30x1.5 38 LOCK 4
Crankshaft gear retaining nut M 22x1 190 GREASE B
Alternator rotor retaining nut M 24x1 270 (•) ENGINE OIL
Oil drain plug M 22x1.5 42
Oil mesh filter M 22x1.5 42
Coolant delivery manifold M 22x1.5 27 LOCK 5
Cooling fan temperature switch M 22x1.5 42 LOCK 4
Oil filler plug M 22x1.5 5 (•)
Clutch drum retaining nut M 20x1 190 (•) GREASE B
Crankshaft blanking cap M 20x1 Fully home with tool THREE BOND 1375B
Gearbox drum locator screw M 16x1.5 30
Oil filter nipple M 16x1.5 42 LOCK 2 or THREE
BOND 1324
Oil filter cartridge M 16x1.5 11 Engine oil on seal
Mesh filter duct plug M 15x1 20 LOCK 5 or THREE
BOND 1375B
By-pass pump cap M 15x1 25 LOCK 5 or THREE
BOND 1375B
Timing drive pulleys ring nut on drive M 15x1 71 GREASE A
Timing drive pulleys ring nut on heads M 15x1 71 GREASE A
Alternator cover inspection plug M 15x1 20 THREE BOND 1215
Oil cooler provision plug M 14x1.5 24 LOCK 5 or THREE
BOND 1375B
Oil cooler provision closing plug M 14x1.5 27 LOCK 5 or THREE
BOND 1375B
Oil cooler nipple M 14x1.5 27 LOCK 5 or THREE
BOND 1375B
Timing drive lay shaft gear retaining nut M 14x1 55 (•) GREASE A
Oil temperature sensor M 12x1.5 18 LOCK 4
Coolant temperature sensor (control unit) M 12x1.5 23 LOCK 4
Spark plugs M 12x1.25 20
Pick-up inspection plug M 12x1 15 LOCK 2 or THREE
BOND 1324
Ground connection screw M 12x1 18 LOCK 2 or THREE
BOND 1324
Cylinder head nuts: 1st tightening
2nd tightening
final torque
M 10x1.5 15
30 (min. 28 max. 32)
48 (min. 45 max. 51)
GREASE C
Oil pump duct plug M 10x1.5 15
fully home with tool
LOCK 5 or THREE
BOND 1375B
Cylinder head studs M 10x1.5 25 LOCK 2 or THREE
BOND 1324