Fujitsu PRIMERGY RX100 S7 - Preliminary Steps; Disconnecting the Power Cables

108 Upgrade and Maintenance Manual RX100 S7
Power supply
6.2.2 Preliminary steps
Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Disabling BitLocker functionality" on page 75
3. "Shutting down the server" on page 59
4. "Extending/removing the server from the rack" on page 60
5. "Opening the server" on page 64
6.2.3 Disconnecting the power cables
Figure 21: Disconnecting the power cables
Ê Disconnect the two power cables from the system board connectors
"PWR2" and "PWR1".