Fujitsu PRIMERGY RX100 S7 - Disconnecting the Front VGA Cable from the System Board; Disconnecting the Front LAN Cable from the Front LAN Card; Removing the Defective Front VGA;LAN Module; Installing the New Front VGA;LAN Module

RX100 S7 Upgrade and Maintenance Manual 341
Management and diagnostics modules
14.3.3.5 Disconnecting the front LAN cable from the front LAN card
Ê Disconnect the front LAN cable from the front LAN card as described in
section "Disconnecting the front LAN cable from the front LAN card" on
page 337.
14.3.3.6 Disconnecting the front VGA cable from the system board
Ê Disconnect the front LAN cable from the system board as described in
section "Disconnecting the front VGA cable from the system board" on
page 337.
14.3.3.7 Removing the defective front VGA/LAN module
Ê Remove the front VGA/LAN module as described in section "Removing the
front VGA/LAN module" on page 338.
14.3.3.8 Installing the new front VGA/LAN module
Ê Install the front VGA/LAN module as described in section "Installing the front
VGA/LAN module" on page 330.
14.3.3.9 Connecting the front VGA cable to the system board
Ê Connect the front LAN cable to the system board as described in section
"Connecting the front VGA cable to the system board" on page 330.
14.3.3.10 Connecting the front LAN cable to the front LAN card
I The front LAN card is already mounted in its holder.
Ê Connect the front LAN cable to the front LAN card as described in section
"Connecting the front LAN cable to the front LAN card" on page 331.
14.3.3.11 Installing the front LAN card
Ê Install the front LAN card as described in section "Installing the front LAN
card" on page 332.