Fujitsu PRIMERGY RX100 S7 - Installing the Riser Module 1; Concluding Steps

366 Upgrade and Maintenance Manual RX100 S7
System board and components
15.3.1.6 Installing the riser module 1
Figure 253: Installing the riser module 1
Ê Insert the riser card into the system board slot.
15.3.1.7 Concluding steps
Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Switching on the server" on page 72
4. "Enabling BitLocker functionality" on page 94
5. "Closing the rack door" on page 73
6. Enable TPM in the system board BIOS. Proceed as follows:
Ê Switch on or restart your server.
Ê As soon as the startup screen appears, press the [F2] function key to
enter the BIOS.
Ê Select the Advanced menu.
Ê Select the Trusted Computing submenu.
Ê Set the TPM Support and TPM State settings to Enabled.