RX100 S7
Upgrade and Maintenance Manual 147
Hard disk drives / solid state drives
7.1.2.3 Removing the 2.5-inch dummy module
I Dummy modules protect free bays against environmental impact.
Remove the dummy module before installing an additional HDD/SSD
module.
Figure 66: Removing the 2.5-inch dummy module
Ê Press both tabs on the dummy module together until the locking mechanism
disengages (1).
Ê Pull the dummy module out of the bay (2).
V CAUTION!
Store the dummy module in a safe place. If you have removed an
HDD/SSD module and do not install a new one in its place, put the
dummy module back in its place for cooling, to comply with EMC
regulations (regulations regarding electromagnetic compatibility), and for
protection against fire. Ensure that the dummy module engages correctly
in the bay.
1
0
0
To Next Page
Loading...
