Fujitsu PRIMERGY RX100 S7 - Concluding Steps; Disconnecting the FBU Adapter Cable from the TFM; Removing the FBU Holder from the Chassis

256 Upgrade and Maintenance Manual RX100 S7
Expansion cards and backup units
9.5.4.3 Disconnecting the FBU adapter cable from the TFM
Figure 165: Disconnecting the FBU adapter cable from the TFM
Ê Disconnect the FBU adapter cable from the TFM.
9.5.4.4 Removing the FBU holder from the chassis
Ê Remove the FBU holder from the chassis as described in section "Removing
the BBU with the BBU holder" on page 251.
9.5.4.5 Concluding steps
Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Switching on the server" on page 72
4. "Closing the rack door" on page 73