Fujitsu PRIMERGY RX100 S7 - Installing the New Expansion Card; Connecting Cables to the Expansion Card; Installing the Riser Module 2

RX100 S7 Upgrade and Maintenance Manual 223
Expansion cards and backup units
Figure 134: Removing the expansion card - slot 1
Ê Remove the two screws (1).
Ê Pull out the expansion card from the riser card slot (2).
9.4.6.5 Installing the new expansion card
Ê Install the expansion card as described in section "Installing the expansion
card" on page 205.
9.4.6.6 Connecting cables to the expansion card
Ê If necessary, connect the cables to the expansion cards as described in
section "Connecting cables to the expansion card" on page 207.
9.4.6.7 Installing the riser module 2
Ê Install the riser module 2 as described in section "Installing the riser module
2" on page 207.
/
0
/