RX100 S7
Upgrade and Maintenance Manual 389
Cables
Ê Route the SGPIO line in the cable clamp (see circle).
Ê Thread the SGPIO line through the recess (see circle).
Ê Connect the RAID card cable to the RAID controller and install the RAID
controller as described in section "Installing an expansion card in
riser module 2" on page 203.
16.1.6 Concluding steps
Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Switching on the server" on page 72
4. "Closing the rack door" on page 73
16.2 Replacing the front panel cable
V CAUTION!
Follow the safety instructions in chapter "Important information" on
page 43.
16.2.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Main steps: tool-less
Field Replaceable Units (FRU)
Average task duration: 5 minutes
To Next Page
Loading...
