226 Upgrade and Maintenance Manual
RX100 S7
Expansion cards and backup units
Figure 135: Removing the TFM
Ê Remove the three screws (1).
Ê Remove the TFM (2).
9.4.7.4 Installing the new TFM
Ê Install the new TFM as described in section "Preparing the FBU" on
page 247.
Ê Connect the FBU adapater cable to the TFM as described in section
"Connecting the FBU adapter cable to the TFM" on page 249.
Ê Install the expansion card as described in section "Expansion cards and
riser modules" on page 199.
9.4.7.5 Concluding steps
Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Switching on the server" on page 72
4. "Closing the rack door" on page 73
To Next Page
Loading...
