RX100 S7
Upgrade and Maintenance Manual 171
Hard disk drives / solid state drives
7.2.5.6 Connecting the cables
Figure 84: Connecting the cables to the 3.5-inch SAS/SATA backplane
Ê Connect the following cables to the SAS/SATA backplane:
– (1) power cable to connector J4
– (2) SGPIO cable to connector J2
– (3), (4) SAS/SATA data cables to connectors SATA1, SATA2 according
the color coding
For the cable plan see section "Cabling" on page 462.
7.2.5.7 Concluding steps
Ê Perform the following procedures:
1. Insert all HDD modules, see section "Installing the 3.5-inch HDD module"
on page 162.
I Make sure that you reinstall the HDD module in the bay it was
located before the SAS/SATA backplane replacement.
2. "Closing the server" on page 66
3. "Installing the server in the rack" on page 68
4. "Switching on the server" on page 72
5. "Closing the rack door" on page 73
1
2
0
3
To Next Page
Loading...
