Fujitsu PRIMERGY RX100 S7 - Replacing the Power Cable for the Backplane; Preliminary Steps; Required Tools

RX100 S7 Upgrade and Maintenance Manual 403
Cables
16.5 Replacing the power cable for the
backplane
V CAUTION!
Follow the safety instructions in chapter "Important information" on
page 43.
16.5.1 Required tools
● Preliminary and concluding steps: tool-less
● Main steps: tool-less
16.5.2 Preliminary steps
Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Locating the defective server" on page 55
3. "Shutting down the server" on page 59
4. "Extending/removing the server from the rack" on page 60
5. "Opening the server" on page 64
Field Replaceable Units (FRU)
Average task duration: 5 minutes