166 Upgrade and Maintenance Manual
RX100 S7
Hard disk drives / solid state drives
An HDD module can only be replaced during operation in conjunction
with a corresponding RAID configuration.
●
All HDD modules (drives) must be uniquely identified so that they can
be reinstalled in their original bays later. If this is not done, existing
data can be lost.
●
Follow the safety instructions in chapter "Important information" on
page 43.
V Only applicable for removing non-defective HDD modules:
Ê Set the drive to "Offline" via the software (RAID controller
configuration software), before removing an HDD module that is not
defective.
7.2.4.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Main steps: tool-less
7.2.4.2 Preliminary steps
Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Locating the defective server" on page 55
3. "Locating the defective component" on page 58
7.2.4.3 Removing the defective 3.5-inch HDD module
Ê Remove the HDD/SSD module as described in section "Removing the 3.5-
inch HDD module" on page 164.
7.2.4.4 Installing the new 3.5-inch HDD module
Ê Install the HDD/SSD module as described in section "Installing the 3.5-inch
HDD module" on page 162.
To Next Page
Loading...
