Fujitsu PRIMERGY RX100 S7 - Concluding Steps; Disconnecting the BBU Cable from the RAID Controller; Installing the Riser Module 2

254 Upgrade and Maintenance Manual RX100 S7
Expansion cards and backup units
9.5.3.7 Disconnecting the BBU cable from the RAID controller
Figure 164: Disconnecting the BBU cable from the RAID controller
Ê Disconnect the BBU cable from the RAID controller.
9.5.3.8 Installing the riser module 2
Ê Install the riser module 2 as described in section "Installing the riser module
2" on page 207.
9.5.3.9 Concluding steps
Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Switching on the server" on page 72
4. "Closing the rack door" on page 73