Fujitsu PRIMERGY RX100 S7 - Replacing SFP+ Transceiver Modules; Removing the Protective Optical Port Plug; Required Tools

196 Upgrade and Maintenance Manual RX100 S7
Expansion cards and backup units
9.3.2 Replacing SFP+ transceiver modules
V CAUTION!
Follow the safety instructions in chapter "Important information" on
page 43.
9.3.2.1 Required tools
● Tool-less
9.3.2.2 Removing the protective optical port plug
Figure 108: Removing the protective optical port plug
Ê If present, remove the protective optical port plug from the SFP+ transceiver
module.
V CAUTION!
Save the protective port plug for future use.
Upgrade and Repair Units (URU)
Average task duration: 5 minutes