Fujitsu PRIMERGY RX100 S7 - Connecting Cables to the Expansion Card; Installing the Riser Module 2

RX100 S7 Upgrade and Maintenance Manual 207
Expansion cards and backup units
9.4.2.6 Connecting cables to the expansion card
Figure 120: Connecting cables - example RAID controller
Ê If necessary, connect the cables to the expansion cards.
9.4.2.7 Installing the riser module 2
Figure 121: Installing the riser module 2
Ê Insert the two riser cards into the system board slots.
Ê If necessary, connect the cables to the other components.