60 Upgrade and Maintenance Manual
RX100 S7
Basic hardware procedures
4.4 Extending/removing the server from the
rack
I In most cases maintenance tasks can be performed while the server is
extended from the rack. However, depending on accessibility or security
guidelines, it may make sense to completely remove the server from the
rack cabinet for maintenance purposes.
V CAUTION!
●
Use the anti-tilt plate to prevent the rack from tipping when installing
the rack. Pulling the server out of the rack without having installed the
anti-tilt plate may cause the rack to tip over.
●
Be careful not to pinch fingers or clothes when sliding out the server
or pushing it back. Failure to do so may cause injury.
●
Follow the safety instructions in chapter "Important information" on
page 43.
4.4.1 Preliminary steps
Opening the cable ties or cable clamps
Figure 2: Example: Unlocking the cable tie of a standard power supply unit
Ê Loosen the cable tie by opening the small locking lever (1).
Ê Open the cable tie (2).
/
0
To Next Page
Loading...
