Fujitsu PRIMERGY RX100 S7 - Removing the 3.5-Inch HDD Module

164 Upgrade and Maintenance Manual RX100 S7
Hard disk drives / solid state drives
7.2.3.3 Removing the 3.5-inch HDD module
Figure 79: Unlocking the 3.5-inch HDD module
Ê Release the locking mechanism as follows:
1. Press the locking button (1).
2. Push the handle of the HDD module fully in the direction of the arrow (2).
The HDD module is now unlocked.
Ê Pull the HDD module out a few centimeters.
Ê Wait for at least 30 seconds.
I This period is necessary for the RAID controller to recognize that an
HDD module has been removed and for the hard disk drive to come
to a stop.
Ê Pull the HDD module out completely.
1
0