Fujitsu PRIMERGY RX100 S7 - Concluding Steps; Preliminary Steps; Removing a Memory Module

RX100 S7 Upgrade and Maintenance Manual 275
Main memory
10.3.2 Preliminary steps
Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Disabling BitLocker functionality" on page 75
3. "Shutting down the server" on page 59
4. "Extending/removing the server from the rack" on page 60
5. "Opening the server" on page 64
10.3.3 Removing a memory module
Figure 179: Removing the memory module
Ê Press the securing clips on both sides of the memory slot concerned
outward (1).
Ê Pull the memory module out of the slot (2).
10.3.4 Concluding steps
Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Switching on the server" on page 72
4. "Enabling BitLocker functionality" on page 94
5. "Closing the rack door" on page 73
/
0
/