Fujitsu PRIMERGY RX100 S7 - Re-Installing the TPM; Concluding Steps

RX100 S7 Upgrade and Maintenance Manual 373
System board and components
15.3.3.4 Re-installing the TPM
Figure 256: TPM spacer
Ê The TPM spacer is already present on the system board.
Ê Reinstall the TPM as described in section "Installing the TPM" on page 365.
15.3.3.5 Concluding steps
Ê Perform the following procedures:
1. Reinstall the system board as described in section "Installing the new
system board" on page 380
2. "Closing the server" on page 66
3. "Installing the server in the rack" on page 68
4. "Switching on the server" on page 72
5. "Enabling BitLocker functionality" on page 94
6. "Closing the rack door" on page 73
I You can find information on configuring the TPM in the "BIOS Setup
Utility" manual.