Fujitsu PRIMERGY RX100 S7 - Concluding Steps; Installing the New 2.5-Inch HDD;SSD Module; Preliminary Steps; Removing the Defective 2.5-Inch HDD;SSD Module

154 Upgrade and Maintenance Manual RX100 S7
Hard disk drives / solid state drives
7.1.4.2 Preliminary steps
Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Locating the defective server" on page 55
3. "Locating the defective component" on page 58
7.1.4.3 Removing the defective 2.5-inch HDD/SSD module
Ê Remove the HDD/SSD module as described in section "Removing the 2.5-
inch HDD/SSD module" on page 151.
7.1.4.4 Installing the new 2.5-inch HDD/SSD module
Ê Install the HDD/SSD module as described in section "Installing the 2.5-inch
HDD/SSD module" on page 148.
7.1.4.5 Concluding steps
Ê Perform the following procedures:
1. "Closing the rack door" on page 73
2. "Performing a RAID array rebuild" on page 95