72 Upgrade and Maintenance Manual
RX100 S7
Basic hardware procedures
4.8 Switching on the server
V CAUTION!
●
Before switching on the server, make sure the top cover is closed. In
order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY RX100 S7 server must not run while the top cover is
removed.
●
Follow the safety instructions in chapter "Important information" on
page 43.
I This step is only applicable to replace or expand non-hot plug
components.
Ê Press the On/Off button to start up the server.
Ê Ensure that the power-on indicator above the On / Off button is lit green.
I For more information see "Connectors and indicators" on page 447.
Ê If BitLocker functionality has been disabled when shutting down the server
(see section "Shutting down the server" on page 59), re-enable BitLocker as
described in section "Enabling BitLocker functionality" on page 94.
4.9 Concluding software tasks
Ê Perform the following software tasks to put the server back in operation:
– "Resetting the boot retry counter" on page 87
– "Verifying the system time settings" on page 91
– "Viewing and clearing the System Event Log (SEL)" on page 91
– "Updating the NIC configuration file in a Linux environment" on page 93
– "Enabling BitLocker functionality" on page 94
– "Performing a RAID array rebuild" on page 95
– "Looking up changed MAC / WWN addresses" on page 96
– "Configuring LAN teaming" on page 98
To Next Page
Loading...
