RX100 S7
Upgrade and Maintenance Manual 451
Appendix
17.2.2 Connector panel
Figure 342: Connector panel
The serial connector COM1 can be used as default interface or to communicate
with the iRMC S3.
LAN connectors
The system board is equipped with a Gigabit Ethernet Controller type Intel
82574L (shared LAN) and a Gigabit Ethernet Controller type 82579LM
(standard LAN). The LAN controllers support transmission rates of 10 Mbit/s,
100 Mbit/s and 1 Gbit/s.
The shared LAN controller also supports WOL functionality by means of Magic
Packet™. It is also possible to start a system via a LAN without a separate boot
hard disk drive. PXE is supported on both shared and standard LAN.
No. Description
1 Global error indicator (orange), CSS indicator (yellow), ID indicator
(blue); (description see preceding section)
2 Management LAN connector (for iRMC S3 server management function)
3 Shared LAN connector (for WOL/PXE/iSCSI function)
4 Serial connector COM1
5 Video connector (VGA)
6 2x USB connectors
7 Standard LAN connector
8 2x USB connectors
/ 0 1 2 3 4 5 6
To Next Page
Loading...
