Fujitsu PRIMERGY RX100 S7 - Connecting the Front VGA Cable to the System Board; Installing the Front VGA;LAN Module

RX100 S7 Upgrade and Maintenance Manual 421
Cables
16.9.10 Installing the front VGA/LAN module
Figure 307: Installing the front VGA/LAN module
Ê Thread the free ends of the cables through the bay.
Ê Push the front VGA/LAN module into the bay from the front (1) until the
locking mechanism engages (2).
16.9.11 Connecting the front VGA cable to the system
board
Figure 308: Connecting the front VGA cable to the system board
Ê Connect the front VGA cable to the system board connector "FRONT VGA".
/
0