Fujitsu PRIMERGY RX100 S7 - Installing the Riser Module 1; Concluding Steps

RX100 S7 Upgrade and Maintenance Manual 339
Management and diagnostics modules
14.3.2.9 Installing the riser module 1
Figure 233: Installing the riser module 1
Ê Insert the riser card into the system board slot.
14.3.2.10 Concluding steps
Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Switching on the server" on page 72
4. "Enabling BitLocker functionality" on page 94
5. "Closing the rack door" on page 73