Fujitsu PRIMERGY RX100 S7 - Required Tools; Preliminary Steps; Removing the Riser Module 1

RX100 S7 Upgrade and Maintenance Manual 363
System board and components
15.3.1.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing the TPM:
– Bit screw driver
– TPM bit insert (*)
(*) For the Japanese market:
– TPM module fixing tool (S26361-F3552-L909)
15.3.1.2 Preliminary steps
Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Disabling BitLocker functionality" on page 75
3. "Shutting down the server" on page 59
4. "Extending/removing the server from the rack" on page 60
5. "Opening the server" on page 64
15.3.1.3 Removing the riser module 1
Figure 248: Removing the riser module 1
Ê Carefully pull out the riser module 1 upward.