Fujitsu PRIMERGY RX100 S7 - Installing the New Memory Module; Concluding Steps

RX100 S7 Upgrade and Maintenance Manual 277
Main memory
10.4.4 Installing the new memory module
Figure 180: Installing the memory module
Ê Carefully press the memory module into the memory slot (1) until the
securing clips on both sides of it engage (2).
10.4.5 Concluding steps
Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Updating the system board BIOS and iRMC" on page 81
4. "Enabling replaced components in the system BIOS" on page 89
5. "Verifying the memory mode" on page 90
6. "Enabling SVOM boot watchdog functionality" on page 89
7. "Switching on the server" on page 72
8. "Enabling BitLocker functionality" on page 94
9. "Closing the rack door" on page 73
/
0
0