352 Upgrade and Maintenance Manual
RX100 S7
System board and components
15.2.1.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Main steps: Phillips PH1 / (+) No. 1 screw driver
15.2.1.2 Preliminary steps
Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Disabling SVOM boot watchdog functionality" on page 76
3. "Disabling BitLocker functionality" on page 75
4. "Shutting down the server" on page 59
5. "Extending/removing the server from the rack" on page 60
6. "Opening the server" on page 64
15.2.1.3 Removing the riser module 2
Figure 237: Removing the riser module 2
Ê Carefully pull out the riser module 2 upward.
To Next Page
Loading...
