Fujitsu PRIMERGY RX100 S7 - Installing the New SATA Cable

RX100 S7 Upgrade and Maintenance Manual 401
Cables
Figure 281: Disconnecting the SATA cable from the system board
Ê Disconnect the SATA cable from the system board.
Ê Remove the SATA cable.
16.4.4 Installing the new SATA cable
Figure 282: Connecting the SATA cable to the system board
Ê Connect the SATA cable to the connector "SATA5-ODD" on the system
board.
Ê Route the SATA cable as shown in the figure.