RX100 S7
Upgrade and Maintenance Manual 357
System board and components
Figure 243: Tools for breaking the UFM
Figure 244: UFM breaking method
Ê Use a long nose pliers and a combination pliers to break the UFM in
half as shown in the figure.
15.2.2.5 Installing the riser module 2
Ê Install the riser module 2 as described in section "Installing the riser module
2" on page 354.
15.2.2.6 Concluding steps
Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Enabling SVOM boot watchdog functionality" on page 89
4. "Switching on the server" on page 72
5. "Enabling BitLocker functionality" on page 94
6. "Closing the rack door" on page 73
To Next Page
Loading...
