Fujitsu PRIMERGY RX100 S7 - Removing the Defective FBU from the Chassis; Removing the Defective FBU from the FBU Holder

RX100 S7 Upgrade and Maintenance Manual 265
Expansion cards and backup units
9.5.6.3 Removing the defective FBU from the chassis
Ê Remove the FBU from the chassis as described in section "Removing the
FBU" on page 255.
9.5.6.4 Removing the defective FBU from the FBU holder
Figure 173: Disconnecting the FBU adapter cable from the FBU
Ê Press down on the locking latch on the FBU cable (see close-up) and
disconnect the FBU adapter cable.