208 Upgrade and Maintenance Manual
RX100 S7
Expansion cards and backup units
9.4.2.8 Concluding steps
Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Updating RAID controller firmware" on page 84
4. "Enabling Option ROM scan" on page 85
5. "Enabling SVOM boot watchdog functionality" on page 89
6. "Switching on the server" on page 72
7. "Enabling BitLocker functionality" on page 94
8. "Closing the rack door" on page 73
9.4.3 Removing an expansion card in riser module 1
V CAUTION!
●
Before installing/removing expansion cards to/from the server, turn
off the server, all peripheral devices, and any other connected
devices. Also unplug all power cables from the outlet. Failure to do so
can cause electric shock.
●
The circuit boards and soldered parts of internal options are exposed
and can be damaged by static electricity. Before handling them, first
touch a metal part on the server to discharge static electricity from
your body.
●
Do not touch the circuitry on boards and soldered parts. Hold the
metallic areas or the edge of the circuit boards.
●
Follow the safety instructions in chapter "Important information" on
page 43.
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
To Next Page
Loading...
