92 Upgrade and Maintenance Manual
RX100 S7
Basic software procedures
Ê Under Maintenance select System Event Log.
Ê Select the message type(s) you want to display:
– Critical events
– Major events
– Minor events
– Informational events
I Note on the SVOM Driver Monitor
The Driver Monitor view gives you an overview of the monitored
components as well as the associated events contained in the system
event log on the managed server.
Under Monitored Components the monitored components are listed. If a
component has the status Warning or Error, you can select it in the list
and click Acknowledge. This confirms the event on the server side. You
may have to log on to the server beforehand. The status of the
component will then be reset to ok. To see the new status you must
refresh the Driver Monitor view with Refresh.
I For detailed information on how to view and sort the SEL using
ServerView Operations Manager, refer to the "ServerView Operations
Manager - Server Management" user guide.
Viewing the SEL using the iRMC web frontend
Ê Enter the ServerView iRMC web frontend.
Ê Select the Event Log and choose the Internal Event Log submenu.
Ê Under Internal Event Log Content the SEL is being displayed. In order to filter
the list, select the check boxes next to the desired event types and press
Apply for the changes to take effect.
I For detailed information on iRMC settings, refer to the "Integrated
Remote Management Controller" user guide.
5.2.11.2 Clearing the SEL
You can clear the System Event Log (SEL) using the ServerView iRMC web
frontend:
Ê Enter the ServerView iRMC web frontend.
Ê Select the Event Log and choose the Internal Event Log submenu.
To Next Page
Loading...
