Fujitsu PRIMERGY RX100 S7 - Removing Expansion Card Slot Brackets; Removing an Expansion Card Slot Bracket; Required Tools

190 Upgrade and Maintenance Manual RX100 S7
Expansion cards and backup units
9.2.2 Removing expansion card slot brackets
V CAUTION!
Follow the safety instructions in chapter "Important information" on
page 43.
9.2.2.1 Required tools
● Phillips PH2 / (+) No. 2 screw driver
9.2.2.2 Removing an expansion card slot bracket
Ê Remove the two M3 x 4.5 mm screws.
Ê Remove the controller from the mounting tabs on the slot bracket.
Upgrade and Repair Units (URU)
Average task duration: 5 minutes