126 Upgrade and Maintenance Manual
RX100 S7
Power supply
6.3.2.2 Preliminary steps
Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Locating the defective server" on page 55
3. Only when replacing a power supply module in a non-redundant
configuration: "Shutting down the server" on page 59
4. "Locating the defective component" on page 58
5. Check which power supply module is defective.
A power supply module is defective when the indicator (1) in figure 44
lights orange. For more information see section "Connectors and
indicators" on page 447.
6.3.2.3 Removing the power cord
Figure 45: Removing the power cord
Ê Open the cable tie.
Ê Remove the power cord from the power supply module.
To Next Page
Loading...
